*This message was transferred with a trial version of CommuniGate(tm) Pro*
Rivets for making display 1919's were available from Sarco. It seems that no matter where you pick up a dummy side plate the whole project runs about $600 when your done(if its a nice job) including the non-gun parts set.
Glenn
LEEnCALIF@aol.com wrote:
> *This message was transferred with a trial version of CommuniGate(tm) Pro*
> What works best to remove cosmolene on weapons? Gasoline???
>
> Does anyone know where I could get a rivet pack for the Browning 1919A4 or
> the demilled right side plate? The ones I've found in shotgun news run about
> $225 for the 80% types. Must something cheaper. Decided not to try to make
> it semi-auto, just too many people would freak out! lol
>
> Somebody recently sent me some info. on an aluminum right side plate, but
> during my recent hard drive crash, I lost all my notes! Sorry.
>
> Thanks in advance...
>
> Jack
>
> PS What the heck is cosmolene anyway?? I know what it does, just not sure
> what it is.
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@uller.skylee.com>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@uller.skylee.com>
> Send administrative queries to <mil-veh-request@uller.skylee.com>
This archive was generated by hypermail 2b29 : Tue Apr 04 2000 - 21:57:16 PDT