Hi Randy,
Thanks for the input.
I tested, with 12V, the connections and found which ones fed the 115V
outlets inside, through circuit breakers and also lit the lights.
I hope this works.
Henry
----- Original Message -----
From: Randy Orpe <sgtorpe@sierratel.com>
To: ygmir <ygmir@onemain.com>
Cc: Milveh <mil-veh@uller.skylee.com>
Sent: Monday, November 13, 2000 9:34 AM
Subject: Re: [MV] Power coupler for S250 and 280 shelters
> Be advised, it may be that one of the connections is 110VAC and one is
> 24VDC, this was how the GRC-142 sets were made. Look carefully at the key
in
> relation to the pin placement. Some shelters used a six pin plug
TRC-145s,
> half male and half female ), those were power in and power out/
>
> Randy
>
> ----- Original Message -----
> From: ygmir <ygmir@onemain.com>
> To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
> Sent: Sunday, November 12, 2000 6:28 PM
> Subject: [MV] Power coupler for S250 and 280 shelters
>
>
> > Hi all,
> > does any one have the cord end to power up these shelters with 115V?
> > they seem about 2.5 inches dia. with about 4 ea. male and female
> > pins/sleeves.
> > Are twist on, one is power in, one out. I would like the "in" but they
> both
> > seem the same.
> > Also, I'm having trouble accessing Alex's web page at Idaho motor pool,
> does
> > anyone know if it's still working?
> > Thanks
> > Henry
> > MVPA 22136
> > and other 'stuff'
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
This archive was generated by hypermail 2b29 : Sun Dec 03 2000 - 20:29:51 PST