At 06:01 AM 11/23/00 -0600, Everett Doyle wrote:
>my .02 worth -- outer edge of seal is metal to metal, without flexible
>pieces that contacts moving part, if metal has the least imperfection you
>can get oil leak -- been there, done that
>
>Everette
I TOO think the sealer goos on the out side steel to steel side of the seal.
my 2 cents worth
> > Hi Listers,
> >
> > The hallowed store of Mutt-like knowledge (aka -20 TM) states that sealant
> > should be applied around the wheel oil seals.
> >
> > What is the point of using an oil seal if you ne
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
> >
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Sun Dec 03 2000 - 20:29:57 PST