K Dewey wrote:
>..........How do you remove the starter. ....... Unable to find the
>mounting bolts
>like on other starters (usually 2 ) Maybe there is so much dirt and crud
>that I am passing over them in my search.........
Take out your copy of TM-10 1435 and turn to page 77, or if you have
Ford Manual Form 3773 (for the Mark II model I ) or the later form 3774
(for the mark Mark II model II and Mark I model I), turn to page 35.
If you don't have these contact Dennis Spence at Portrayal Press right
away and get a copy!
The manual states that you should "Loosen and remove the two long cap
screws holding the starter motor in place and remove the starter."
Hope this helps........
Jim
NOTE NEW ADDRESS----NOTE NEW ADDRESS---NOTE NEW ADDRESS------AS OF
JANUARY 4, 2001---------
Jim Gilmore
13 Broadway 3rd floor
Jim Thorpe, PA. 18229
570-325-5216 phone
This archive was generated by hypermail 2b29 : Tue Aug 07 2001 - 09:34:10 PDT