You do not have to disassemble anything on the M35 tranny to remove it. It
comes out as a unit.
Joe Garrett
cell 425-344-1402
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of Frank Cox
Sent: Wednesday, September 05, 2001 2:13 PM
To: Military Vehicles Mailing List
Subject: Re: [MV] Question About M35A2 Transmission Replacement...
Jim
Just finished installing a trans in a 5 ton M819. We had to remove the
shift lever from the gearbox. I think you will have to do the same on
your unit. If you do, be sure to remove the entire top cover. DO NOT
TRY TO REMOVE THE SMALLER TOWER BY ITSELF!! Previous mechanic did that
on the 5 ton and wound up breaking the pivot housing with the forks etc.
remaining in the gear box.
Just a thought,
Frank Cox
MVPA 14530
45 GMC353 DUKW
66 Kaiser Jeep M35A2 w/w
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Mon Oct 08 2001 - 10:58:56 PDT