Hi Bobby. I didn't send the rear leg yet, I had to use it today for a
parade (look at http://www.deltaforce.net/~amnon/deuce/ ).
It worked OK with both right rear legs although I wouldn't want to fire a
gun off of the setup, it is only attached with one bolt to each leg. I will
take the leg off this week and send it to you so you can see if it works for
you. The front leg you sent worked great, I just need to find an ammo can
mount for it. I also need the brackets/adapters that go between the legs
and the ring. There is something I couldn't figure out. The welded
brackets on the ring are not spaced out evenly, there are two which are
closer together. Do you, or anybody else here, know how the ring should be
oriented as far as those brackets
Rick, the ring is great, after a little sanding and paint it looks brand new
(as you can see), thanks for the great deal.
Now I have a question about the cradles I have. I got one from Gene some
time ago, and it has a short shank. The cradle I got from Rick with the
ring has a long shank. The trolley I got from Rick works fine with the long
shank cradle (I guess they were made for each other :-). Will the short
shank cradle work in it too (too heavy to lift up to try). The short one
has something the long one doesn't, on one side it has something that looks
like a spring housing, about 4" in diameter and maybe 1.5" deep with a big
hex in the middle. This cradle is heavier and I would to use it. The ammo
tray is interchangable between the two.
I also have a little story about changing the axle seals, but will put this
in another message.
Shalom Ya'll
Amnon Nissan
Deltaforce
919-852-2121
http://www.deltaforce.net
Host, Computers 2K1
on 850 The Buzz (AM 850) in Raleigh NC
Sundays 8-10am
http://www.850thebuzz.com/compute.html
This archive was generated by hypermail 2b29 : Fri Dec 07 2001 - 00:36:57 PST