From: bjpendleton@charter.net
Date: Mon Sep 15 2003 - 13:19:19 PDT
remove the screws in the upper corners. use a block of wood and a hammer and
slowly and carefully peck the top section off. Then work the glass out
through the opening in the top. I just took my frames and glass to the glass
shop and let them do it.
Bobby Joe Pendleton II
----- Original Message -----
From: "Chris Stansbury" <chris_stansbury@hotmail.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, September 15, 2003 2:23 PM
Subject: [MV] how to take a deuce windshield apart??
> Hey guys,
> I know this has been covered before, but I didn't save the message. I
need
> to replace the glass in an otherwise good windshield. I would like to get
> it out in one piece to take it to the glass shop. How do you separate the
> frame to get the glass out? Im going to do a write-up for the website on
> this one so I'd like to do it right. Thanks.
> Chris
>
>
>
> Chris Stansbury, O.D.
> 1301 Lee Street East
> Charleston, WV 25301
> 304-343-3363
>
> _________________________________________________________________
> Need more e-mail storage? Get 10MB with Hotmail Extra Storage.
> http://join.msn.com/?PAGE=features/es
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:24:25 PDT