From: David Cole (DavidCole@tk7.net)
Date: Fri Mar 26 2004 - 08:53:22 PST
That's some pretty specialized material. Are you trying to find those
filler materials to avoid cracking the armor when welding it? That ER90
is suppose to require a preheat before welding to avoid cracking.
Unless you are planning on using your armor, you might be better off with
some different, more forgiving materials. I know that nickel based rods
will weld a lot of different high tensile material without cracking also,
and you can buy it in small quantities.
You might be able to buy a small quantity of rod or the end of a spool of
wire from a welder that specializes in high pressure boiler welding, etc.
Good Luck,
Dave
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
On Fri, 26 Mar 2004 09:08:49 -0500, Richard Lathrop <lathrrs@snip.net>
wrote:
> I am hoping someone maybe has either of these mil surplus as I don't need
> 33lb spool of ER-90, the smallest commercial package and I only need a
> few rods not 60lbs of the 308MoT-16.
>
> Thanks, Rick
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
-- Dave
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:14 PDT