From: rcb.com@att.net
Date: Wed Apr 14 2004 - 05:00:00 PDT
The round plates are 8" in diameter
drive shaft is marked "spicer"
universals are all pressed in
width of the universals are aprox 5 3/8"
universal caps are aprox 2" in diameter with
bolted plates covering them
located in Pittsburgh, PA.
>
> >The round plates on each end have 8 bolt holes.
>
> Do you know what U joints it uses, mechanics type or traditional Spicer type
> (do the caps of the U joint bolt to the flange or are they pressed in to a
> yoke)? Also measure the width of the cap and the length across the caps.
> Not that it would be worth much to me, depending on where you are that is???
>
> later,
>
> je
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:34 PDT