From: Nigel Hay -MILWEB (Nigel@milweb.net)
Date: Mon Oct 18 2004 - 00:22:41 PDT
On the WW2 Halftracks and scout cars the easiers way to do this is from the
internal facing side as it doesnt seem to be anything like as hard.
NIGE
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of J. Forster
Sent: 17 October 2004 19:53
To: Military Vehicles Mailing List
Subject: Re: [MV] drilling armor plate
I'd be careful doing this because the heat affected zone can easily exceed
the
finished hole diameter.
-John
Rick v100 wrote:
> Dan,
>
> You could pierce it will either a plasma or a oxy fuel
> torch and then finish the hole by drilling it out.
>
> Rick
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:51 PDT