Re: [MV] Removing CARC WITHOUT Sanding

From: Sonny Heath (sonny@defuniak.com)
Date: Wed Oct 27 2004 - 05:25:36 PDT


What does CARC actually mean?

Sonny

----- Original Message -----
From: Glenn Shaw <mpmutt@mtaofnj.us>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Tuesday, October 26, 2004 10:57 PM
Subject: Re: [MV] Removing CARC WITHOUT Sanding

Just need to wear a decent mask, like you would with any paint sanding.
Normal precautions. No Problem.

Glenn

-----Original Message-----
From: Sonny Heath [mailto:sonny@defuniak.com]
Sent: Tuesday, October 26, 2004 10:38 PM
To: Military Vehicles Mailing List
Subject: Re: [MV] Removing CARC WITHOUT Sanding

.I haven't removed any paint on any of mine yet, well I actually did grind
the paint from my deucenahalf front bumper and rear bumperettes, so what
are you all saying that some paints on these trucks will harm you if you
grind or sand it off?

Please advise.

Sonny

----- Original Message -----
From: Baker, George R. - Eastman <grbaker@eastman.com>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Tuesday, October 26, 2004 11:31 AM
Subject: Re: [MV] Removing CARC WITHOUT Sanding

Guys there's only one way to deal with CARC...sandblast it! Be sure to use a
good respirator and be careful not to over heat the metal, when I come to a
stubborn area I move on then come back to it later after the metal cools.
There's no substitute for a clean, blasted surface.

GRB

, STEVE Hill wrote:
>At the risk of resurrecting the CARC debate, I need to know if the use
of
>paint stripper on CARC poses any additional hazards than it would with
>ordinary paint. I know I don't want to use a sander or grinder on
CARC,
>so it would seem that by using stripper I could get rid of the paint
>without releasing the particles into the air. But, would the fumes be
any
>more dangerous with CARC?

=Mil-Veh is a member-supported mailing list=
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To
reach a human, contact <ack@mil-veh.org>

===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To
reach a human, contact <ack@mil-veh.org>

=Mil-Veh is a member-supported mailing list=
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>



This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:53 PDT