From: Jim Newton (jnewton@laurel.com)
Date: Mon Nov 08 2004 - 16:09:13 PST
Hi Everyone...
What are the dimensions of a clutch alignment tool for the deuce
multifuel's clutch disc?
Specifically I need the following info:
(A) OVERALL LENGTH:
(B) DIAMETER OF SHAFT THROUGH CLUTCH PLATE SPLINES:
(C) DIAMETER OF SHAFT INTO PILOT BEARING:
(D) LENGTH OF SHAFT INTO PILOT BEARING:
(You can refer to the drawing at www.cucv.net/clutch.gif)
I need to make one before Wednesday.
The TMs talk about the "TOOL KIT, CLUTCH ALIGNING" (NSN
5180-00-449-3785...check it out on MILDOCS) but that's a complete kit
used for all vehicles, not just the deuce.
I stupidly threw away the old fried transmission 6 months ago...I
should have taken the clutch shaft off! But I didn't.
Thank you!
--Jim "Ike" Newton
o 1984 M1007 CUCV Military Suburban 6.2 Liter (378 CID) Turbo-Diesel Engine 5/4 Ton Cargo Capacity, 4WD
o 1971 M35A2 Military Troop/Cargo Truck "Deuce and a Half" 478 CID Turbo-Diesel Multi-Fuel Engine Air Shift Front Axle 2 1/2 Ton Cargo Capacity, 6WD
See These Trucks at www.CUCV.NET Keyword Searching of 22,000 Electronic TMs at www.MILDOCS.com
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:37:39 PDT