From: Mike Maynard (mike@wesleyscott.com)
Date: Thu Sep 15 2005 - 20:04:36 PDT
I had always thought, that if it didn't disengage that the clutch plate was
fine.... that it was only damaged if it slipped? Didn't think they could
'stick'.
Am I wrong?
-----Original Message-----
From: Michael Howell [mailto:doctormv@frontiernet.net]
Sent: Thursday, September 15, 2005 11:04 PM
To: Mike Maynard; Military Vehicles Mailing List
Subject: RE: [MV] Clutch?
Quoting Mike Maynard <mike@wesleyscott.com>:
> Sounds to me like your clutch itself isn't shot. Bad 'master'
> cylinder?
> Slave? Or hose between? Seems more like it....
>
> If it were an older truck, I would say linkage :-)
>
>
> It might be worth a few minutes laying under it and looking up... it
> might
> be obvious.
>
>
>
>
> Mike
>
> -----Original Message-----
> From: Michael Howell [mailto:doctormv@frontiernet.net]
> Sent: Thursday, September 15, 2005 10:53 PM
> To: Military Vehicles Mailing List
> Subject: [MV] Clutch?
>
> I guess I may be on foot now.
>
> About 2 miles form the GA MVPA rally, the clutch broke on my 1998 GMC
> 1 ton dual wheel pickup. I was pulling a trailer full of mv stuff to
> sale at the rally. It has a 5 speed manual and less than 40000 miles
> on
> it. It had started to feel funny about half way to Atlanta. I felt
> a
> pop when shifting into 5 after stopping at a redlight. At the next
> light I found the clutch would not disengage. I had to switch the
> key
> off at red lights and crank it in gear to go. I could shift from 1st
> to 2nd (i didn't try to go higher). I managed to limp to the show
> site
> and park the truck at the rally. A Friend of my son followed us to
> Atlanta so I have a ride for now. Any suggestions? Anybody know a
> good transmission shop in Atlanta? I am giving serious consideration
> to trading it in on a new ride. Know a good dealer?
>
> Mike
> Tishomingo, Mississippi
>
I did check the master cylinder and it is full. It wasn't shifting
smoothly for most of the trip. But it was completely disengaging.
Felt like it was grabbing or something. I fear the clutch plates are
damaged. It is already on its second slave cylinder.
Mike
Tishomingo, Mississippi
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:27:06 PDT