[MV] Wanted - Rear axle shaft for a 1945 CMP HUP
MWCC (waterman@tellink.net)
Sun, 25 Oct 1998 15:49:12 -0500
Wanted - Rear axle shaft for a 1945 CMP HUP I need the left or long =
side axle shaft. The shaft measures as follows: wheel flange is 5.25" =
outside diameter 8 bolt pattern 4.5" center to center of the bolt holes =
which are approximately 7/16" diameter, flange is .438 thick. Shaft is =
1.491 diameter machined surface and measures 40.5 to 40.75 length from =
back of flange to end of shaft and has 10 splines. If you have a spare =
shaft you would be willing to sell please contact me via e-mail at =
waterman@tellink.net or at p_waterman@mwcc.mass.edu or by phone =
603-878-1650 mailing address Philip Waterman, P.O. Box 116, Temple, New =
Hampshire 03084. This is a running restored truck so I would like to =
find the part in the near future. You may have seen this truck and its =
sister lorry a C60S CMP known as Beauty and Beast.
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.