[MV] need curtain info

MVTrucker@aol.com
Wed, 12 May 1999 13:41:50 EDT

List,
I'm pulling stuff out of storage and am trying to figure out what these
four canvas end curtains I have are made for. The ORD numbers are
stencilled on.
(1)- US Ord 7707286 39" center height x 60" w, approximately 28" high
sides (measured from the bottom to just where the curved corner
starts. It has a 9"x 22-1/2" window opening with a flap. Three twist
type fasteners hold the flap closed. The top is very arched.

(2)- This next flap was in a box, but maybe the box is not the right one.
The label on the box identifies this as 2520-200-1963, Side Curtain.
This can't be a side curtain by looking at it. A tag tied to it has the
number 78-0072-5 It measures 65" wide x 43" high (at center), has
an arched top and a sewn in 7"x 22-1/2" plastic window. Manila rope.

(3)- US Ord 7411557 64" wide x 44" high at center of arch, 39-1/2"
sides. The top corners are almost squared. Has a 10-1/2" x 23"
window opening with a flap. Twist type fasteners for the flap.

(4)- US Ord 7707286 measures 63" wide x 40" high, 9"x22" window
opening with twist fasteners to hold the flap closed. Black nylon rope.
Fairly straight top with sharp top corners. I think this is for an M37.
Same ORD number as (1) above, but a whole lot different curtain.

Any help in identifying these flaps will be very much appreciated.
Joe Young MVtrucker@aol.com

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.