Re: [MV] M37 Wheel Cyl. repair or replace?

Mark R. (gloryhunter@rapidnet.com)
Sat, 15 May 1999 02:15:18 -0600

Dan Bever wrote:
>
> List,
> I have a leaking RF wheel cyl on my M37. I have not taken it apart as
> yet so this may be a bit premature as I don't know the condition of the
> bore.

Dan,

I'm in the middle of rebuilding the wheel/master cylinder on my M37.
Very easy to do.
I had to actually use a drift to knock two of the pistons out of the
front cylinders.
They honed very nicely without any scratches or pitting. Sounds like
you may just have a leaking seal/cup. If you are going to rebuild the
RF do the other also. If you already don't know, the NAPA #'s for the
wheel cylinder kits are NAPA #6, master cylinder kit is NAPA #1.

-- 
Mark  ICQ# 149347O3          
Rapid City, SD
'68 M416
'66 M274-A5       ______                   
'51 M37          |      |                 
   _____________ |______|________         
  |    ___      ||      |  ___  |         
  |   /###\     ||______| /###\<|         
  |__/#   #\____||_______/#   #\|]        
      #   #               #   #
       ###                 ###     
Check out the Unofficial Dodge M37 Page
http://home.mainsite.com/lathrrs/


===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.