Re: [MV] HMMWV differential rebuild tools?

From: Tom Bauer (tomb@carr.org)
Date: Sun Jul 16 2000 - 15:16:24 PDT

i have replaced bearings in MANY differentials over the years and the
only thing i do is to use the old shims in the old locations. bearings
are made to the same specifications so they are all the same. to pre
load the pinion shaft tighten it down to the same position of the nut
(fairly obvious) and you are done...........
tom

This archive was generated by hypermail 2b29 : Mon Aug 07 2000 - 22:16:01 PDT