I just made my own adapter out of an old two pin slave ''recept'' and a
NATO adapter, I got two big wire connectors and sweated them on the wires,
and then on the NATO end and wrapped it with black tape. Works good. I think
I have about ten bucks in it.
Ed Morgan
-----Original Message-----
From: Ted Hintopoulos <hint@northnet.org>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Date: Sunday, October 28, 2001 10:12 AM
Subject: [MV] Older 2 Pin Slave cable to 1 pin coaxial NATO vehicle socket?
>
>Hello all:
>
>Is there such an adapter?:
>Older 2 Pin Slave cable to 1 pin coaxial NATO vehicle socket?
>
>I've seen an adapter for the other way around, NATO cable
>to 2 pin socket, but I'm looking for the 2 pin cable to NATO socket.
>Why? Everything I have cept one is 2 pin.
>
>Thanks again everyone.
>Ted H.
>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Fri Dec 07 2001 - 00:36:29 PST