Re: [MV] 2 parts needed for M35A2 (heater)

• Next message: jim gilmore: "FORD WRENCHES - GPW's"
• Previous message: Jim Newton: "Re: [MV] 2 parts needed for M35A2 (heater)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

DANGER WILL ROBINSON..... BUYER BEWARE....

    Be advised, the picture does not show the mounting shelf needed for
mounting the blower and heater core box inside the left front fender of the
M35A2.

Ron

----- Original Message -----
From: "Jim Newton" <jnewton@laurel.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, December 09, 2001 12:34 PM
Subject: Re: [MV] 2 parts needed for M35A2 (heater)

Hi Kenneth...

>What is the going rate on one of these heater kits? I bought one for $145.

Colemans Surplus has the complete Winterization kits for $200
including the padded mask for the front grille of the deuce. Here's
the URL:

http://www.galleria-e.com/cgi-bin/colemans.storefront/en/product/462601

Good luck.

--
Jim "Ike" Newton
 o 1984 M1007 CUCV Military Suburban
   6.2 Liter Turbo-Diesel Engine
   5/4 Ton Cargo Capacity, 4WD
 o 1971 M35A2 Military Troop/Cargo Truck "Deuce and a Half"
   478 Cubic Inch Turbo-Diesel Multi-Fuel Engine
   Air Shift Front Axle
   2 1/2 Ton Cargo Capacity, 6WD
 See them at: http://www.CUCV.net
=Mil-Veh is a member-supported mailing list=
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>

• Next message: jim gilmore: "FORD WRENCHES - GPW's"
• Previous message: Jim Newton: "Re: [MV] 2 parts needed for M35A2 (heater)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Sun Jan 06 2002 - 22:26:51 PST