From: w7ls (w7ls@blarg.net)
Date: Thu Aug 15 2002 - 15:18:54 PDT
I have a PE-175 (maybe it's a PE-75. Have to look, again) and the
complete manual, if that is a help. It's listed as being 2.5 KW. It's on
a skid and weighs about 300 pounds. Jim
"Steve & Jeanne Keith" <cckw@attbi.com> wrote:
> The output is 110 I believe. It is only 3 phase which is unusual for an
> output that low unless maybe it was only to run a motor.
>
> It weighs 308 pounds and is skid mounted. This one is in nice condition
>
> Steve
>
> ----- Original Message -----
> From: "kuhrick" <kuhrick@comcast.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Thursday, August 15, 2002 5:04 PM
> Subject: Re: [MV] 3 kw ww2 genset
>
>
> > there was made a 3 kw 3 phaze gen set that usewd allmost a jeep sized
> water
> > cooled motor
> > it had 3 110 volt outputs to grond and 220 if wared phaze to phaze
> > and all 3 legs made 220 3 phaze
> > i seen one runing 3 weeks a go it runs as good as new
> > big and havey but will out live you if cared for
> > low speed too
> >
> >
> > ----- Original Message -----
> > From: "Steve & Jeanne Keith" <cckw@attbi.com>
> > To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> > Sent: Thursday, August 15, 2002 2:47 PM
> > Subject: [MV] 3 kw ww2 genset
> >
> >
> > > I am picking up a 3 kw genset from ww2. It is 3 phase shich is unusual
> for
> > > that low current. It also turns at 1200 rpms to make 60 hz which for a
> > > genset,
> > > modern or old is unusual.
> > >
> > > The only thing I can think of that this would be used on was the ww2
> cckw
> > > machine shop van to run the motors of the lathe etc
> > >
> > > Ideas?
> > >
> > > Thanks
> > > Steve AKA Dr Deuce
> > >
> > >
> > >
> > > ===Mil-Veh is a member-supported mailing list===
> > > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > > To switch to the DIGEST mode, send e-mail to
> <mil-veh-digest@mil-veh.org>
> > > To reach a human, contact <ack@mil-veh.org>
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:39:08 PDT