Re: [MV] Plastic jerry can spout

From: micdunn (micdunn@ev1.net)
Date: Wed Sep 18 2002 - 20:39:37 PDT


You can use the screw in type, available at most auto parts stores. Or you
can use the military type, it has a large rubber ring which expands and
tightly seals by pushing a lever 90 degrees. I prefer the military type
(known as a 'donkey dick') because it is much faster and easier to use.
Where do you get one?
Someone on this list is sure to know.
Ronzo, no 'donkey' jokes, okay?
-Sarge

----- Original Message -----
From: "David Jenkins" <GPW1942@bellatlantic.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Wednesday, September 18, 2002 7:21 PM
Subject: [MV] Plastic jerry can spout

> Can someone tell me what type of spot is used with the plastic jerry cans.
> Anyone know where to get one?
> Dj
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>



This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:21:22 PDT