From: Dave Jenkins (gpw1942@bellatlantic.net)
Date: Sun May 11 2003 - 06:33:35 PDT
Hi Ed,
The Bridge weight plate should go on the driver's side. The plate bolts to a
small piece of "L" channel aluminum which bolts to the front bumper. Two bolts
"L" channel to bumper, two bolts plate to "L" channel. Make sure you place all
the numbers in the holder as the pressure keeps them all in place. I'll send a
picture if you like.
Dj
Ed Kirkley wrote:
> OK for all of you GU-RUs out there, what is the proper mounting procedure
> for a bridge plate kit on an M-1009? I got mine with the bridge plate kit
> installed and it seemed to be fairly weak. It was just held on by two bolts
> through the bumper and bent back and forth with the wind. It broke off
> today and I have a full kit that I got still in the bog and bag. It have
> more parts and bolts by a long shot than the one that was on my M-1009.
> Does anyone have the installation instructions or know where I can find a
> drawing showing the correct way to mount this kit using all of the parts?
>
> Thanks,
>
> Ed
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:29 PDT