m151 fording with ROPS

From: Klein, Bob (bklein@fgcu.edu)
Date: Sun Aug 31 2003 - 10:03:20 PDT


Hello everyone,

I can't seem to find any info on the installing the deep water fording kit with the ROPS kit on the m151a2. My question is: the exhaust bracket on the back corner of the vehicle has a "tab" that covers the area where the new location of trailer receptacle goes because of the ROPS system (the tab outlines the original area where the trailer receptacle goes without the ROPS). What is the standard procedure for dealing with this? My first inclination is to cut this tab off straight across to accomodate the new trailer receptacle location. I want to make sure this is what is correct before I cut my lovely exhaust bracket. The holes are already drilled for the new trailer receptacle location so moving the trailer receptacle is not an option. Thanks one and all.



This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:23:39 PDT