From: Baker, George R. - Eastman (grbaker@eastman.com)
Date: Wed Nov 05 2003 - 06:20:12 PST
In my days or maybe I should say "Daze" as a Harley Mechanic I used a
pump type oil can with a clear hose on the end that fit tight on the
bleeder which would allow you to pump fluid back through the master
cylinder. Just pump till there's no more air bubbles then tightened the
bleeders.
GRB
-----Original Message-----
From: Recovry4x4@aol.com [mailto:Recovry4x4@aol.com]
Sent: Wednesday, November 05, 2003 9:13 AM
To: Military Vehicles Mailing List
Subject: Re: [MV] Brake bleeder recommendations
I have heard of individuals using a plastic pressure sprayer adapted to
the
mastercylinder. Granted it doesn't have a bladder so you would have to
watch
it continuously so that it doesn't go empty and fill the system with
air. Might
even build one myself! Shouldn't be a big deal to plumb it in through
the
vent fitting in the deuce MC.
Kenny
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:25 PDT