CUCV Glow Plug Problem

From: vislocky (vislocky@prodigy.net)
Date: Thu Nov 27 2003 - 08:32:36 PST


Hello Listers,

I've got a problem with my 1985 CUCV M009 glow plug system. Recently I had
the start relay go bad in mid-crank causing the starter to keep cranking
even after I turned the key off. Before I could get the battery
disconnected, several wires got real hot and smoked causing the insulation
to burn off several wires. I replaced the start relay and repaired the
wiring. I found all my glow plugs were burned out (ohm check showed 0). I
replaced the glow plugs and tried to crank it up. The glow plug relay
cycles (quickly) and the light comes on but no start. Checked the new glow
plugs and they are all shorted out now too. Voltage check shows 24 volts
going to the glow plugs when it cycles. Shouldn't only 12 volts be going to
the glow plugs??? Is something shorted out?? Any clues would be greatly
appreciated. I'm stumped on this one. Happy Thanksgiving. Kevin MVPA
#8173



This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:26:29 PDT