CUCV Removing Dynamic Balancer

From: Bruce Beattie (bruce@eecs.berkeley.edu)
Date: Mon Jan 12 2004 - 22:25:59 PST

• Next message: Neil E. Amrhein: "Re: [MV] quite possibly have a serious problem with my 6.2L.... a long story"
• Previous message: Fred Martin: "Re: [MV] Shop Building recommendations"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Group,
    I tried to remove the &**^%%&* Bolt that holds the dynamic Balancer
on to the
crank shaft with my 1/2 inch impact wrench. But no go. It just doesn't
have enough power.

    What is the best way to lock the crank shaft so I can put a breaker
bar on the bolt?

Thanks in advance for any help!
Bruce MVPA 23824

• Next message: Neil E. Amrhein: "Re: [MV] quite possibly have a serious problem with my 6.2L.... a long story"
• Previous message: Fred Martin: "Re: [MV] Shop Building recommendations"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:01 PDT