Re: [MV] m35 rear pto

From: m35products (m35prod@optonline.net)
Date: Sun Feb 08 2004 - 14:12:54 PST


Yes, there is a stock rear-facing application. It is a casting and gear box
that bolts on in place of the rear plate on the PTO unit. The two outputs
can be used independently. It requires a separate handle (and bracket),
which comes up in the same slot as the winch handle. The PTO's are available
for around $300. The handles and bracketry are sometimes hard to find,. a p
bloom, www.M35products.com

----- Original Message -----
From: "quiggy" <quigstro@netcarrier.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, February 08, 2004 4:23 PM
Subject: [MV] m35 rear pto

> A friend of mine would like to put a rearward pto on his M35 to run a
> fertilizer sprayer. It already has a winch, so that takes up his existing
> pto. Is there a way to put another on? The access on the trans' other side
> is blocked by the frame. I only know about WW2 dodges, and M211s. Thanks
in
> advance, Brian Q.
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>



This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:28:32 PDT