From: Fred Martin (mung@in-touch.net)
Date: Mon Mar 01 2004 - 08:39:29 PST
Yep...APB is right on the Lynch pins at the tractor places...they are
7/16" diameter and are used to hook up implements to tractors. The last
handfull that I bought were made in India but they're okay, never had
one to fail...especially if you take a piece of wire and wire the ring
so that it can't flop over and lose it's locking abilities. Under a
tractor brush can do this. I have also seen them made in 1/4" size.
Fred Martin
m35products wrote:
> Bruce, if you are in need of originals, I don't know the answer. If you are
> just looking to make them functional, you can get linch pins that fit
> perfectly at any tractor supply or heavy equipment repair place. That's what
> I did. Arthur
>
> ----- Original Message -----
> From: "Bruce Kalin" <pball@csionline.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Sunday, February 29, 2004 8:18 PM
> Subject: [MV] Need pins for deuce tow bar
>
>
>
>>Anyone have or, know where I can get a complete set of pins for the
>>deuce (medium) tow bar?
>>I also need the pins for the small and the medium shackles. Any help
>>will certainly be appreciated. I would like to have mytow bar
>>operational for the 2004 East Coast Convoy. Of course, I don't expect to
>>need to use the towbar ............ you just never know.
>>Thanks in advance,
>>
>>Bruce Kalin
>>2004 East Coast Convoy coordinator
>>http://www.EastCoastConvoy.com
>>
>>
>>
>>===Mil-Veh is a member-supported mailing list===
>>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>>To reach a human, contact <ack@mil-veh.org>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:08 PDT