From: Neil E. Amrhein (neil@compu-powr.com)
Date: Thu Mar 11 2004 - 03:58:02 PST
I checked McMaster's site yesterday and I browsed my catalog last night. They have some flange head bolts with the indented head, but they do not have any with flat washers built onto them. They were available in coarse thread, I think. I cannot remember if the rail bolts are course or fine thread.
----- Original Message -----
From: "Bobby Joe Pendleton" <bjpendleton@charter.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, March 09, 2004 4:11 PM
Subject: Re: [MV] M274 Mule rail attach bolts
> http://www.mcmaster.com/
>
>
>
> ----- Original Message -----
>
> From: "John Rozell" <jrozell@bellsouth.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Tuesday, March 09, 2004 9:58 AM
> Subject: [MV] M274 Mule rail attach bolts
>
>
> > Does anyone know of a source for the 3/8" fine thread indented hex bolts
> > that attach the rails and rear engine guard to the deck of the M274
> > mule? I have seen automotive fender bolts, with the attached flat
> > washer, which are similar but are not quite an exact replacement. While
> > the flat washer could be added, I really would like to maintain the OEM
> > look of the indented hex head. Perhaps there is a modern substitution?
> >
> > I have already checked with Bill Watson and he is out of stock.
> >
> > The 20P mule manuals callout the following:
> > Bolt, Assembled Washer Platform Channel 8716890, FSN 5306-571-6985
> >
> > Thanks.
> >
> > John Rozell
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:29:11 PDT