From: Sonny Heath (sonny@defuniak.com)
Date: Tue Aug 31 2004 - 18:21:45 PDT
Larry,
Look on the side of the tire, the mfg. recommended pressure is printed in
small letters. It will depend on the load range of the tire. It will
probably be 35 pounds and if not it will most likely be 45.
Sonny
----- Original Message -----
From: Larry Tighe <larryradio@worldnet.att.net>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Tuesday, August 31, 2004 3:31 PM
Subject: [MV] M151A2 Tire Pressure
> Just replaced the NDT's with radials.
>
> The NDT's required 22 lbs pressure. Can I assume the radials would be the
> same pressure? Or, is there so much difference in tires that that's not a
> good assumption? Anyone know what is the correct pressure if not 22 lbs.
>
> Many thanks,
>
> Lar
>
>
> www.antiquetelephone.com
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:34:23 PDT