Re: [MV] drilling armor plate

From: J. Forster (jfor@quik.com)
Date: Sun Oct 17 2004 - 10:52:48 PDT

• Next message: chance wolf: "Re: [MV] BURGUNDY SPRAY PAINT FOR THE DASHPAD"
• Previous message: Rick v100: "Re: [MV] drilling armor plate"
• Maybe in reply to: Bobby Joe Pendleton: "Re: [MV] drilling armor plate"
• Next in thread: Douglas Greville: "Re: [MV] drilling armor plate"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I'd be careful doing this because the heat affected zone can easily exceed the
finished hole diameter.

-John

Rick v100 wrote:

> Dan,
>
> You could pierce it will either a plasma or a oxy fuel
> torch and then finish the hole by drilling it out.
>
> Rick

• Next message: chance wolf: "Re: [MV] BURGUNDY SPRAY PAINT FOR THE DASHPAD"
• Previous message: Rick v100: "Re: [MV] drilling armor plate"
• Maybe in reply to: Bobby Joe Pendleton: "Re: [MV] drilling armor plate"
• Next in thread: Douglas Greville: "Re: [MV] drilling armor plate"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:36:51 PDT