From: m35products (m35prod@optonline.net)
Date: Fri May 27 2005 - 14:33:38 PDT
Blame it on Aervoe.
----- Original Message -----
From: "Steve & Jeannie Keith" <cckw@comcast.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, May 27, 2005 5:30 PM
Subject: [MV] ** What the H is Idaho made of...***
> I have begun restoring my Chevrolet K51 Panel truck that I bought sorta
> on Ebay a few years ago. I took it outside to pressure wash the caked on
> gunk etc and any loose paint.
>
> The 3200 psi 4gpm pressure washer was no match for Idaho durt! I have
> NEVER seen this and I have cleaned many HMVs with this pressure washer.
> There was a mud wasp nest and I put the pressure washer nozzle up to one
> of the holes and it remained...! If I go slowly, the pressure washer will
> remove
> paint normally!
>
> Again, I have never seen anything like this. When I took out the
> transmission,
> I had to get some of the caked on gunk away from the bolt heads. Not with
a
> screwdriver you don't. I had to use a wood chisel and hammer!!!!!
>
> What the hell gives in Idaho?
>
>
> Steve AKA Dr Deuce
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 22:42:56 PDT