From: kuhrick (kuhrick@comcast.net)
Date: Tue Sep 06 2005 - 02:14:05 PDT
At 02:30 AM 9/6/2005, archie road wrote:
>Kenny,
> I have a old rockwell 4" angle air grinder that i use 1/8th inch
> thick abrasive discs on and it will cut something like that just fine,
> almost as good as with a machine.
and if you stop for cooling it don't have to hirt the heat treating
you don't have to grand till its cherry red
>Recovry4x4@aol.com wrote:
>
>>Here's a question for all you metalurgists and welders. I have an extra
>>input shaft from a deuce transmission. I want to cut the gear portion
>>off. Is there anyway to temper the steel with heat so that I can cut it
>>with my bandsaw? I know I can chop it with the heat wrench but prefer the
>>cleaner cut of the saw.
>>Thanks,
>>Kenny
>>
>>===Mil-Veh is a member-supported mailing list===
>>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>>To reach a human, contact <ack@mil-veh.org>
>>
>>.
>>
>>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:27:03 PDT