From: m35products (m35prod@optonline.net)
Date: Mon Sep 05 2005 - 21:44:44 PDT
Lathe?
----- Original Message -----
From: <Recovry4x4@aol.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, September 06, 2005 12:27 AM
Subject: [MV] Cutting a Transmission Input Shaft
> Here's a question for all you metalurgists and welders. I have an extra
input
> shaft from a deuce transmission. I want to cut the gear portion off. Is
there
> anyway to temper the steel with heat so that I can cut it with my bandsaw?
I
> know I can chop it with the heat wrench but prefer the cleaner cut of the
saw.
> Thanks,
> Kenny
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Oct 28 2005 - 23:27:03 PDT