Yes, this is correct...
>
> 2. The clamps screwed to the frame that hold the frame in the upright
> position to the dash are heavy brass castings, whereas most I have seen are
> stamped steel affairs...again, what would be correct for the very early
> GPW?
I have see these also, and believe this may be correct style also...
>
> 3. In theory (that is, without 50+ years accumulation of rust), can the
> complete inner windshield frame with glass be slid apart from the outer
> tubular frame by just pulling it out the drivers side? I seem to be having
> trouble getting the two assemblies apart.
>
You might try spraying penitrating oil where the two slide apart,
letting it soak for awhile, don't be in to much of a hurry trying to
take the two apart, also work the inner windshield open and closed,
trying to break the two assemblies apart.
> Thanks in advance for the help.
>
> -Rob
Good Luck,
Ron
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.