----------
> From: OKMTRPOOL@aol.com
> To: mil-veh@skylee.com
> Subject: [MV] GPW ENGINE REBORING
> Date: Saturday, February 07, 1998 6:17 PM
>
> What is the correct diameter to have the cylinder bored to for (1) a .010
> oversize (2) a .020 oversize (3) .030 oversize? What are the actual
diameters
> of these sizes of oversize pistons? (OK, I know the answer is going to be
> simple, but would somebody just post it?)
>
> ===
> To unsubscribe from the mil-veh mailing list, send the single word
> UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.
===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.