Re: [MV] Spark plug adapters

Glenn Shaw (dogstar@gis.net)
Tue, 23 Jun 1998 08:00:41 -0400

Ive never had any problems with the solid state ignition either in my M151. What
are you using adapters for? The plugs should just go right in to the head.
That's always the way I've seen them. : )
Glenn Shaw M151A2

JStinson90@aol.com wrote:

> The gap should be set at: 0.032-0.036
> in. (0.812-0.914 mm)
> using feeler gage
> Straight out of : TM 9-2320-218-20-1-1 page 4-58 Also make sure that you
> have the spark plug gasket.
>
> I guess its preference!! but, I like the solid state. I've never had any
> problems out of the solid state but have had problems out of the points (The
> points can't get any moister in it at all) I had my M151A2 submerged (stuck)
> under water for about 4 long hours until I was rescued the points were never
> the same so I changed to the solid state. Got stuck again haven't had any
> problems!!!!!!!!!
>
> Your "JEEP" nut !!!!!!!
> Jeff
> MVPA Menber # 18907
> 62 M151
> 67 M151A1w/M4 pedistal&Cradle,M60(dummy)AN / VRC-47(radio)heater,fording kit
> 71 M151A2 w/ROPS,heater
> 67 M416 trailer
>
> ===
> To unsubscribe from the mil-veh mailing list, send the single word
> UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.