Re: [MV] 1A08-III Military Standard Engine Questions

Gordon.W.I. McMillan (gwim2@student.open.ac.uk)
Wed, 22 Sep 1999 08:21:29 +0100

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Previous message: Shaun Hayes-Holgate: "[MV] M-43 cylinder head stamp"
Maybe in reply to: Kevin Vislocky: "[MV] 1A08-III Military Standard Engine Questions"

No idea of the technicalities, but my standard setting for the mixture on
any engine (manual notwithstanding) is to put it fully home and then back
it out one turn. This is nearly always a good starting position for finer
adjustment, and if it is a conventional carb and the screw is backed out
noticeably more than one turn it would run like a dog, which sounds about
right.

Gordon

===
To unsubscribe from the mil-veh mailing list, send the single word
UNSUBSCRIBE in the body of a message to <mil-veh-request@skylee.com>.

Previous message: Shaun Hayes-Holgate: "[MV] M-43 cylinder head stamp"
Maybe in reply to: Kevin Vislocky: "[MV] 1A08-III Military Standard Engine Questions"