Well, at least I don't feel quite so bad now :)
Thank you
Jon
> I did that, too. Go to a NAPA shop or similar. Take the line with the ferules
> with
> you. Match them up on the spot. Tell them what it's for, so you get the right
> material for the tubing. Jim
>
> uniquemachine wrote:
>
> > While re-torqueing the head bolts on my LDT 465-1C motor, I accidentally
> damaged
> > one of the black plastic tubes that connect to the tops of the fuel
> injectors
> > and connect them all together.
> > ( fuel return line?? 1/4 " ????) I need to replace it, it is about 4"
> to 5"
> > long and also the little brass ferules on each end. Any suggestions,
> > recommendations or tips/advice?
> >
> > TIA
> > Jon
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Fri Dec 07 2001 - 00:36:29 PST