From: Brian Thomas Bancale (armor@nac.net)
Date: Thu Feb 28 2002 - 04:44:06 PST
Hi John and list.
I had found bearings for my M8 turret they $380.00 ea.
I had one reel bad one, peeled back the tin seal cleaned and cleaned
then grease bend the cover back down that's 5 years ago. Still works
fine my turret is not powered never , my 10 year old nephew can spin the
turret with ease.
The bearing was full of rust and badly pitted its just fine now.
Sounds like the same bearings .
Brian
"Hutterer, John - Deltec" wrote:
>
> List,
>
> Anyone have any ideas for locating a source for the support bearings for a
> Stuart turret? The Crew Chief says that we need three of them, with the
> following description:
>
> The
> bearing part number is a SKF number 466317. They are a
> tapered sealed bearing. Diameter is 5-1/8 inches on
> outside and 4-7/8 inches on inside. Looks like 1-15/16
> inch opening for the shaft to slide through. Thickness
> of the bearing is 1-1/4 inches.
>
> I'll look through some supply books myself, but wondered if anyone else had
> any ideas.
>
> Thanks,
>
> John
>
> John Hutterer
> Sen. Eng. Lab. Tech.
> Deltec Inc.
> 651-628-7107
> john.hutterer@deltec.com
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Mon Apr 08 2002 - 00:24:57 PDT