M38A1

From: Greg Booth (gbooth@kc.rr.com)
Date: Wed Oct 22 2003 - 18:21:08 PDT

• Next message: Daniel Dolan: "WANTED Photocopy of a good ID Data Plate for a Correct QUAD FIFTY TRAILER - NOT the two wheeled variety"
• Previous message: patrick jankowiak: "Re: [MV] M35 Clutch solutions and Tranny problems"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Thanks all for the info on the wheel bearings I was able to get all of them
plus the seals. I decided that since I was doing brakes on all four wheels
that I would do bearings and seals all the way around. I am now on the back
wheels and I think I need a hub Puller to get the hub off and then a slide
hammer to remove the axle. Any suggestions on how to do this with not all
the right tools? Thanks
Greg Booth MVPA # 24369
M274-A5
M38A1

• Next message: Daniel Dolan: "WANTED Photocopy of a good ID Data Plate for a Correct QUAD FIFTY TRAILER - NOT the two wheeled variety"
• Previous message: patrick jankowiak: "Re: [MV] M35 Clutch solutions and Tranny problems"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:25:03 PDT