From: Ryan Gill (rmgill@mindspring.com)
Date: Sat Jul 17 2004 - 15:16:09 PDT
At 5:11 PM -0400 7/17/04, James Shanks wrote:
>If a front end loader or bulldozer is available
>dig a sloping ramp in front of it so the Deuce
>cargo bed drops low enough to use comealongs
>from the sides to slide it on. Once you get a
>few feet on the bed pull the truck forward
>until the S-250 rests flat on the floor and then
>finish winching using the comealong.
> Other option is hire a heavy duty 18
>wheeler sized hydraulic wrecker crane to lift
>and set it on would be the easiest route.
>
What about sliding the S250 up a set of ramps
with some castors or dollies on the base to
reduce resistance? Some castor bases can be had
for not much with some lumber and castor wheels.
Ramps will be more tricky, but some lumber and
some hard work should net you a wooden ramp you
can knock back down once its all loaded.
--
--
Ryan Gill rmgill@SPAMmindspring.com
----------------------------------------------------------
| | | -==----
| O--=- | | /_8[*]°_\
|_/|o|_\_| | _________ | /_[===]_\
/ 00DA61 \ |/---------\| __/ \---
_w/|=_[__]_= \w_ // [_] o[]\\ _oO_\ /_O|_
|: O(4) == O :| _Oo\=======/_O_ |____\ /____|
|---\________/---| [__O_______W__] |x||_\ /_||x|
|s|\ /|s| |s|/BSV 575\|s| |x|-\| |/-|x|
|s|=\______/=|s| |s|=|_____|=|s| |x|--|_____|--|x|
|s| |s| |s| |s| |x| |x|
'60 Daimler Ferret '42 Daimler Dingo '42 Humber MkIV (1/3)
----------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:53 PDT