From: Bjorn Brandstedt (super_deuce@hotmail.com)
Date: Mon Oct 14 2002 - 10:19:48 PDT
Patrick,
There is an outside possibility that the pressure relief valve on the axle
is clogged. Pressure build-up could cause the seal(s) to leak.
When cleaning the relief valve, remove it and bench check it. Try breathing
thru the valve, it should let you exhale but not inhale. It only takes about
1/2 psi to blow it open.
Some manuals suggest that tapping on the cap of the valve will clear it, but
I have found that not to be enough.
If that's not it, then you will have to take the whole thing apart again,
I'm afraid.
I too have a leaky seal, it's the right rear rear hub. I know I need a new
seal. Just havn't gotten to it yet.
Good luck,
Bjorn
>From: "Ronzo" <rojoha@attbi.com>
>To: <mil-veh@mil-veh.org> (Military Vehicles Mailing List)
>Subject: Re: [MV] M35 axle leaking again!
>Date: Mon, 14 Oct 2002 08:55:48 -0400
>
>Looks like you did everything right. And your hub cross section is a
>corker!! (no pun intended)
>Ronzo
>
>
>----- Original Message -----
>From: "Patrick Jankowiak" <eccm@swbell.net>
>To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
>Sent: Monday, October 14, 2002 12:17 AM
>Subject: [MV] M35 axle leaking again!
>
>
>
> > I sure am frustrated!
> > Any ideas where I went wrong?
>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:24:08 PDT