From: Bjorn Brandstedt (super_deuce@hotmail.com)
Date: Sat Jun 05 2004 - 11:52:43 PDT
The original hubs are hardened throughout and some people may not be able to
machine them at home.
Always good to see different solutions to a problem.
Heck, I made a pair with bearings, even...
Replace one of the drive flanges in the rear with one extra front hub and
you have got it made.
Bjorn
>From: milveh <milveh@carr.org>
>To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
>Subject: Re: [MV] How to make your own lockouts for the M35 Rockwell 240
>axle
>Date: Sat, 5 Jun 2004 13:29:24 -0400
>
>what a waste of time!! just machine the splines out of a spare set of front
>drive plates. or ask kenny...............
>tom
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:33:22 PDT