RE: Sandblasting/Data plates/Advice ?????

From: Nigel Hay MILWEB (nigel@milweb.net)
Date: Mon Dec 12 2005 - 09:34:57 PST


Just use generic Duck tape over them and they will survive. If you put
thick grease over duck tape, it absorbs impact of sandblasting.

NIGE

-----Original Message-----
From: Military Vehicles Mailing List [mailto:
mil-veh@mil-veh.org]On
Behalf Of movnmanj1@aol.com
Sent: 12 December 2005 17:43
To: Military Vehicles Mailing List
Subject: Re: [MV] Sandblasting/Data plates/Advice ?????

Hi guys,
       Since nobody apparently wants the old M62, I am going ahead with
my resto/repair project. However, it will require a complete
sandblasting and was wondering how you guys protect the data plates ?
Removal? If so, I assume that you drill the rivets out and replace
them with a regular pop rivet ? Any advice would be greatly
appreciated. In fact, any do's and don'ts in regards to total vehicle
sandblasting.

Thanking all in advance,
John

===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to <mil-veh-off@mil-veh.org>
To reach a human, contact <ackyle@gmail.com>
Visit the searchable archives at http://www.mil-veh.org/archives/



This archive was generated by hypermail 2.1.4 : Tue Jul 18 2006 - 21:37:01 PDT