Well magnesium burns very well when heated so I'm sure it requires a controlled
atmosphere to prevent it from catching on fire at high temp. I'd check with a
specialty welding shop, but I'd guess that a tig welder properly outfitted would
do the trick.
Dave
>>>>>>>>>>>>>>>>>>>>>>>>>>>>.
Emmett Thompson wrote:
> Hello List
> Does anyone out there know what is used to weld magnesium. Also what would
> you use to "plug" the holes that "BUBBA" drilled in a magnesium deck on a
> MULE?
> I have started on my 1958 M-274 and have about 6 coats of paint to get off
> and am rebuilding the Willys engine not to mention attempting to plug up the
> holes
>
> Thanks in advance
> Emmett
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Wed Apr 04 2001 - 08:10:47 PDT